Photograph the original unit
Capture the module front, underside, charging connection, remote control, charger label and the opening in the furniture.
Replacement & retrofit solutions
Replace the light. Keep the furniture.
Find a suitable rechargeable RGB LED module for an existing illuminated table, chair, bar counter, planter, ice bucket or other translucent PE product.
A practical second life
The furniture can remain useful after its original light fails.
Batteries age, charging parts wear and older light modules can stop responding after years of use. Replacing the internal light engine can extend the working life of an otherwise serviceable illuminated product.
If the original supplier or model is unknown, we can review photos and measurements to identify a suitable standard module or discuss an adapted replacement.
Replacement, not guesswork
Match the physical and electrical details before ordering.
A similar appearance does not guarantee compatibility. The replacement must fit the furniture opening, mounting points, available depth, charging arrangement and accessory system.
Compatibility process
Four steps to identify the right replacement direction.
Measure the installation
Check the module diameter, mounting-hole distance, available internal depth and the size of the furniture opening.
Identify the charging system
Confirm whether the original unit uses direct charging, induction charging or a removable battery arrangement.
Review a suitable replacement
We compare the information with our standard module range and advise whether an existing model or an adapted OEM solution is appropriate.
Measure before matching
Diameter alone is not enough.
Record the flange diameter, screw-hole spacing, opening size and internal clearance. These details help prevent a replacement from sitting too high, too low or outside the available mounting area.
Charging system
Direct and induction charging are different platforms.
Send photos of the original charger, charging base and module underside. Never assume a charger or remote from another system is electrically compatible.
Correct integration
The light engine belongs inside the hollow furniture body.
The LED diffuser and light source face into the translucent shell so the furniture can distribute the light. The mounting flange and bottom access area must sit correctly against the service opening.
Installation and sealing should be completed by a competent technician. Final waterproof performance depends on the complete furniture assembly, not the module alone.
Extend product life
Restore the light without replacing the complete furniture piece.
Find a replacementReplacement overview
From the failed unit to a compatible replacement direction.
This visual guide shows the information needed for an initial compatibility review.
Compatibility request
Send the original module details before ordering.
We will compare the information with our 60, 85, 117, 120, 175 and 200 mm platforms. A compatibility review is not a guarantee until the physical and electrical requirements are confirmed.
- Original module front and underside photos
- Furniture opening and mounting-hole photos
- Diameter, hole spacing and installation depth
- Charger label and remote-control photos
- Required quantity and destination country
Frequently asked questions
Before selecting a replacement module.
Can one replacement module fit every brand of LED furniture?
No. Compatibility depends on diameter, mounting-hole position, installation depth, charging method, operating voltage and sealing structure. We review the original unit before recommending a replacement.
What if the original supplier is no longer available?
Send clear photos and measurements of the original module and furniture opening. We can compare them with our standard platforms and assess whether a compatible or adapted module is possible.
Can the original remote control or charger be reused?
Sometimes, but compatibility must be confirmed. Remote frequency, control protocol, connector type, polarity and charger output can differ, so a matching accessory set may be required.
Will the replacement keep the same waterproof performance?
The module rating is only one part of the system. Final waterproof performance also depends on the furniture opening, gasket, screw pressure, orientation and correct sealing during installation.